Block Paving Cleaning and Renovation
Remember how good it looked when it was newly installed? Remember how proud you were of your new investment?
Unfortunately over time, the inevitable weeds set in, moss fills the joints and crevices and a layer of general dirt and grime cover the surface. Our Driveway Cleaning process can get it back to looking like new.
Sterling Cleaning & Maintenance use industrial pressure washers fitted with high pressure cleaning attachments to remove all unsightly moss / algae / weeds and dirt. We then apply new kiln dried sand to stabilise the area and leave the block paved area looking - and functioning like new. We use the appropriate tools & methods to avoid damaging the surface of any paving.
"I didn't realise the block paving had a coloured pattern in it, until you finished cleaning it!" J Johnson - Duston
CALL STERLING CLEANING & MAINTENANCE ON 01604 710700 OR EMAIL FOR yOUR FREE QUOTATION
We guarantee you will be totally amazed at the transformation our cleaning process will make to the appearance of your block paving - at a very realistic cost!
How we achieve these results
Kill Weeds - we apply a high strength weed-killer to block paving 5-8 days before we are due to clean the area. This allows the chemical to penetrate into the roots of the weeds and kill them.
Clean Paved Area - we use an industrial pressure washer with a high flow rate, combined with various high pressure attachments to blast away all weeds, algae, dirt and grime.
Clean Affected Areas - after pressure washing the block paving, we rinse down the entire area with clean water, including any areas that have been affected by over spray, such as walls and fences. We also ensure that any windows that have been affected with dirty water are properly cleaned.
Apply Moss Inhibitor - after the block paving is clean, we apply a moss inhibitor. Even though all of the moss will have been removed, moss spores remain on the surfaces. The inhibitor will kill any remaining spores.
Re-sand Joints - the block paving is allowed to dry before we return to apply the new kiln dried sand to the paved area. The new sand is brushed into the joints, stabilising the paved area. We then remove any excess sand from the surface leaving the area in its original condition. The new sand is normally applied the following day, after allowing the newly cleaned area to dry.
YOUR AREA OF BLOCK PAVING WILL NOW LOOK AS GOOD AS WHEN IT WAS INSTALLED
Have a look and see for yourself!
CALL STERLING CLEANING & MAINTENANCE ON 01604 710700 OR EMAIL FOR YOUR FREE QUOTATION